Gradient Rhinestone Bow Transfer Strip 3 inch 75mm

This Gradient Rhinestone Bow Transfer strip fits over a 3 inch 75mm grosgrain ribbon. The strips are made with DMC hot fix stones, 70mm wide x 33cm long and are sold in pairs. You are not buying a ready made bow.

Gradient Rhinestone Bow Transfer

Use these pretty heat transfer rhinestone bow strips to bling out a solid colour cheer bow. You can use it on one side or both. If the length of transfer it a little long for your design trim it at the flat end and use for centre strips on this or other bows.

Instructions to use these rhinestone transfers

Have your heat press (or Iron with steam turned off) set to 170 – 175 degrees Celsius.

Place ribbon flat on the base of the heat press or ironing board.

Peel off white backing sheet

All the rhinestones should be attached to the clear carrier sheet.

Place the rhinestone design on the ribbon.

Press for 20 to 25 seconds. If using an iron make sure you press each section for a similar length of time. You should use something between the iron and carrier sheet to prevent spot burning.

Rhinestone sheets are cold peel. This means you need to wait until the rhinestones are cool before trying to remove the carrier sheet.

Peel off the carrier sheet starting at one corner and smooth peel off at a slow pace.

We do our best to keep a range of unique ribbons, hair bow hardware, bling buttons, cheer bow supplies, Christmas Ribbons and other items in stock for your crafting pleasure.

Want to know the latest news from Sarah Lauren? Like us on Facebook!

The best selection of ribbon craft ideas can be found at Sarah Lauren.